Unleash the power hiding in your factory ECU. Neuspeed engineers reprogram your ECU chip to optimize ignition timing under part throttle and full throttle load, and raise the rev-limiter and top speed governor. Horsepower is increased by approximately 5-7hp at the wheels. CARB approved (D236-10) for models up through 2002 when used with a K&N air filter or Neuspeed P-Flo. 91 octane or higher fuel must be used with this chip.
FOR 1995 VR6 VEHICLES ONLY: If your ECU number ends in "AF", "BM", "EA", or "CR", your P-Chip must be soldered to the circuit board at Neuspeed's Headquarters in California. Upon ordering we will email you instructions on where and how to ship your ECU to Neuspeed. For instructions on locating your ECU and ECU Number, click the link below.
PLEASE NOTE: Upon placing your order we will email you instructions on how to locate your ECU and how to ship it to Neuspeed for the installation. You will be required to pay the shipping to and from Neuspeed. Once Neuspeed receives your ECU the total turnaround time is roughly 2-3 days. If you need assistance locating your ECU and ECU Number, please click here for instructions on Locating Your ECU
