Molded from ABS plastic and professionally upholstered, 42 Draft Design's A-pillar gauge pods are perfect for holding a single gauge. Unlike the typical A-pillar pod, 42's pod is designed to be positioned at the lowest point possible without blocking the defrost vent. Their pod fits 2 1/16” (52mm) gauges of any type. The pod is large enough to accommodate mounting brackets, wire and tubing with ease. A built in wire trail is used to cleanly route wires and tubing below the dashboard.

Installation is solid and simple. Designed to wrap securely around the A-pillar, tabs of excess fabric extend from 3 mounting points. Use contact cement, hot glue, Velcro®, or tape to attach the mounting tabs to the back of the stock A-pillar. This product requires no permanent modification and leaves the A-pillar in original condition. Some 2001 and later VW vehicles use A-pillar mount airbags. A-pillar pods should NOT be used on these vehicles.

This Kit Includes:
-42 Draft Designs Gray A-Pillar Pod
-VDO -30Hg -25 PSI Boost Gauge
-Boost Gauge Tubing Kit
-Blue or Red Led 

This Kit Fits:
This solution is designed to be used on 1.8T motors. It will also fit 2.0 and VR6 motors with turbochargers or superchargers installed. TDI owners please see our TDI specific gauge solutions.